filename: tfs 1220m.doc version 1.1 20.11.2012 vectron international filter specification tfs 1220 m 1/5 vectron international gmbh potsdamer stra?e 18 d 14 513 teltow / germany tel: (+49) 3328 4784-0 / fax: (+49) 3328 4784-30 e-mail: tft@vectron.com vectron international gmbh reserves the right to ma ke changes to the product(s) and/or information con tained herein without notice. no liability is assumed as a result of their use or application. no rights under any patent accompany the sale of any such product(s) or information. measurement condition ambient temperature: 22 c input power level: 0 dbm terminating impedance: input: 50 output: 50 characteristics remark: the maximum attenuation in the pass band is defined as the insertion loss a e . the nominal frequency f n is fixed at 1220.0 mhz without any tolerance or li mit. the values of absolute attenuation a abs are guaranteed for the whole operating temperature range. the frequency shift of the filter in the op erating temperature range is included in the production tol erance scheme. d a t a typ. value tolerance / limit insertion loss a e 4.0 db max. 4.9 db nominal frequency f n 1220.0 mhz passband pass band ripple 0.1 db f n max. 3 1.5 mhz db absolute attenuation a abs 0.3 mhz ... 1180 mhz 53 db min. 45 db 1180 mhz ... 1200 mhz 45 db min. 30 db 1200 mhz ... 1210 mhz 33 db min. 16 db 1210 mhz ... 1212 mhz 21 db min. 9 db 1228 mhz ... 1230 mhz 13 db min. 9 db 1230 mhz ... 1240 mhz 20 db min. 16 db 1240 mhz ... 1400 mhz 51 db min. 45 db 1400 mhz ... 1700 mhz 46 db min. 40 db 1700 mhz ... 2000 mhz 42 db min. 35 db group delay ripple within pb 19 ns max. 100 ns operating temperature range otr 22 c storage temperature range -45 c ... +90 c temperature coefficient of frequency tc f * -40 ppm/k - input power level - max. 10 dbm *) ? fc(hz) = t c f (ppm/k) x (t-t a ) x f cat (mhz) generated: checked / approved:
filename: tfs 1220m.doc version 1.1 20.11.2012 vectron international filter specification tfs 1220 m 2/5 vectron international gmbh potsdamer stra?e 18 d 14 513 teltow / germany tel: (+49) 3328 4784-0 / fax: (+49) 3328 4784-30 e-mail: tft@vectron.com vectron international gmbh reserves the right to ma ke changes to the product(s) and/or information con tained herein without notice. no liability is assumed as a result of their use or application. no rights under any patent accompany the sale of any such product(s) or information. filter characteristic filter characteristic filter characteristic construction and pin connection (all dimensions in mm) 1 2 3 4 5 6 1,2 max. 0,6 0,75 3 ,0 +/-0,15 0,6 0,30x0,30 1 3 6 4 date code 50 test circuit l1 saw l2 2 5 1, 3, 4, 6 c20m c47 1 ground 2 input 3 ground 4 ground 5 output 6 ground date code: year + week c 2012 d 2013 e 2014 ... 1 201 401 601 801 1001 1201 1401 1601 1801 2001 -80 -72 -64 -56 -48 -40 -32 -24 -16 -8 0 frequency in mhz magnitude in db 1210 1212 1214 1216 1218 1220 1222 1224 1226 1228 1230 -20 -18 -16 -14 -12 -10 -8 -6 -4 -2 0 frequency in mhz magnitude in db
filename: tfs 1220m.doc version 1.1 20.11.2012 vectron international filter specification tfs 1220 m 3/5 vectron international gmbh potsdamer stra?e 18 d 14 513 teltow / germany tel: (+49) 3328 4784-0 / fax: (+49) 3328 4784-30 e-mail: tft@vectron.com vectron international gmbh reserves the right to ma ke changes to the product(s) and/or information con tained herein without notice. no liability is assumed as a result of their use or application. no rights under any patent accompany the sale of any such product(s) or information. stability characteristics after the following tests the filter shall meet the whole specification: 1. shock: 500g, 18 ms, half sine wave, 3 shocks eac h plane; din iec 68 t2 - 27 2. vibration: 10 hz to 500 hz, 0,35 mm or 5 g respe ctively, 1 octave per min, 10 cycles per plan, 3 pl ans; din iec 68 t2 - 6 3. change of temperature: -55 c to 125c / 30 min. each / 1 0 cycles din iec 68 part 2 ? 14 test n 4. resistance to solder heat (reflow): reflow possible: twice ma x.; for temperature conditions refer to the attached " air reflow temperature conditions" on page 4; packing tape & reel: iec 286 ? 3, with exception of value f or n and minimum bending radius; tape type ii, embossed carrier tape with top cover tape on the upper side; max. pieces of filters per reel: 3000 reel of empty components at start: min. 300 mm reel of empty components at start including leader : min. 500 mm trailer: min. 300 mm g do w ct f e g d1 p2 p1 po bo ao pull off direction pin marker typ date code ko t a c n w 1 w 2 the minimum bending radius is 45 mm. tape (all dimensions in mm) w : 8,00 0,3 po : 4,00 0,1 do : 1,50 +0,1/-0 e : 1,75 0,1 f : 3,50 0,05 g(min) : 0,75 p2 : 2,00 0,05 p1 : 4,00 0,1 d1(min) : 1,50 ao : 3,25 0,1 bo : 3,25 0,1 ct : 5,3 0,1 reel (all dimensions in mm) a : 180 w1 : 8,4 +1,5/-0 w2(max) : 14,4 n(min) : 60 c : 13,0 0,2
filename: tfs 1220m.doc version 1.1 20.11.2012 vectron international filter specification tfs 1220 m 4/5 vectron international gmbh potsdamer stra?e 18 d 14 513 teltow / germany tel: (+49) 3328 4784-0 / fax: (+49) 3328 4784-30 e-mail: tft@vectron.com vectron international gmbh reserves the right to ma ke changes to the product(s) and/or information con tained herein without notice. no liability is assumed as a result of their use or application. no rights under any patent accompany the sale of any such product(s) or information. air reflow temperature conditions conditions exposure average ramp-up rate (30c to 217c) less than 3c/ second > 100c between 300 and 600 seconds > 150c between 240 and 500 seconds > 217c between 30 and 150 seconds peak temperature max. 260c time within 5c of actual peak temperature between 10 and 30 seconds cool-down rate (peak to 50c) less than 6c/second time from 30c to peak temperature no greater than 300 seconds temperature / c time / s max. 260 c 217c 10 ... 30 s 30 ... 150 s max. 300 s chip-mount air reflow profile
filename: tfs 1220m.doc version 1.1 20.11.2012 vectron international filter specification tfs 1220 m 5/5 vectron international gmbh potsdamer stra?e 18 d 14 513 teltow / germany tel: (+49) 3328 4784-0 / fax: (+49) 3328 4784-30 e-mail: tft@vectron.com vectron international gmbh reserves the right to ma ke changes to the product(s) and/or information con tained herein without notice. no liability is assumed as a result of their use or application. no rights under any patent accompany the sale of any such product(s) or information. history version reason of changes name date 1.0 generation of development specification. s. springfeldt 04.07.2012 1.1 generation of filter specification. c. sch?nbein 20.11.2012
|
